Interface introduction
Offline version¶
In the real-time mode, the software interface is mostly the same as SC3, and only the differences are introduced below.
-
Select the device
Click this button to enter the device selection interface. Click and select the control panel you want to use.
-
Connect the device
Open the device scan and connection interface.
-
Screenshot
Capture the content of the current workspace and save it as a png image.
-
Download the firmware
It is only available when the device supports real-time mode communication, and is used to download the real-time mode firmware corresponding to the device.
-
Switch programming mode
The programming mode switch button can be switched to real-time mode or upload mode. If the device does not support switching programming modes, this button will be grayed out.
-
Settings
-
Check for update
Check if there is an updated version of the extended resource
-
Check for main update
Check if there is an updated version of ircBloqV4
-
Clear cache and restart
Clear the locally downloaded update and temporary files of the compiled project and restart the software
-
install driver
Install the drivers of the hardware devices used in the software
-